Follow our illustrated blog on Embedded Software Architecture

How to build a hybrid solar/wind energy harvester?

Device-internal current and voltage sensing – part 2

Attopilot 50V 180A A few weeks ago we tested the Attopilot 50V 90A. Results were ok, we only noticed a small gap between measured and real amps. Today we show you the experimentation results of the 180A  Attopilot sensor board. Again, we used the Deans connectors and quite a lot of solder to connect the Attopilot device […]

Share

PMD1 sensor board: our first hardware component

We are pleased to announce the creation of our very first hardware component: the PMD1 sensor board. We won’t let you wait, here is a beautiful image: Now, let us start with the global picture. The sensor board is part of Power Management Decision 1 (see Figure on the right). PMD1 decides whether the power […]

Share